How To Finish Bottom Of Drywall In Garage: The Basics

In this article, we will go over the basics of how to finish bottom of drywall in garage. We will cover some good advice and tips on what you need to prepare before starting. We will also go over how to complete the task of finishing bottom of drywall in garage with quality results.

What Tools and Materials Needed

If you’re planning on finishing the bottom of your drywall in your garage, you’ll need to gather a few tools and materials first. Here’s what you’ll need:

-Tape measure
-Scissors or a sharp knife
-Heavy duty stapler
-Drywall screws
-1/2″ to 1″ drywall screws
-Drywall saw
-Plywood or OSB board
-Construction adhesive
-Cementitious backer board
-Thin set mortar
-Notched trowel
-5 gallon bucket

How To Finish Bottom Of Drywall In Garage?

The basics of finishing the bottom of drywall in your garage are actually quite simple. With a little bit of patience and the right tools, you can easily get the job done and have a nice, clean looking garage in no time. Here are the basics of how to finish the bottom of drywall in your garage:

1. Gather your supplies. You will need some drywall compound, a putty knife, a sanding block, and some joint tape.

2. Cut your joint tape to size. You want to make sure that the joint tape is slightly longer than the seam that you are going to be covering.

3. Apply the joint tape. Using your putty knife, apply a thin layer of drywall compound over the seam and then place the joint tape on top. Be sure to smooth it out as you go so that there are no air bubbles or wrinkles.

4. Let it dry. Once you have applied the joint tape, let it dry for at least 24 hours before proceeding to the next step.

5. Sand it down. Once the joint tape is completely dry, use your sanding block to lightly sand down the area so that it is smooth and level with the rest of the wall.

6. Apply your paint. Now that the area is smooth and level, you can go ahead and apply your paint. Be sure to use a primer first so that the paint will adhere properly and then finish it off with a top coat of paint.

How to Apply One Coat of Flat Prepaint for Finish on Bottom of Drywall in Garage

Assuming you have already chosen the paint you want to use for the finish on your bottom of drywall in garage, here are the basic steps for applying one coat of flat prepaint:

1. Make sure the surface is clean and free of any debris or dirt.

2. Use a primer specifically designed for use on drywall. This will help the paint to better adhere to the surface and provide a more even finish.

3. Once the primer is dry, apply a thin layer of paint using a brush or roller designed for use with latex paints.

4. Let the paint dry completely before applying a second coat, if desired.


If you’re thinking about finishing the bottom of your drywall in your garage, there are a few things you need to know first. In this article, we’ve covered the basics of how to finish special interior design so that you can get started on your project. We’ve also provided a few tips and tricks to help you get the best results possible.

News Reporter

Leave a Reply

Your email address will not be published. Required fields are marked *