When you move your shower, it can be a tedious task to replace the shower pan without removing the tile. This blog article will teach you how to easily replace your shower pan without having to remove anything.
How to Easily Replace A Shower Pan Without Removing The Tile Underneath
If you are like most homeowners, you probably don’t think much about your shower pan. After all, it’s just a piece of plastic or metal that sits on the floor and collects water. But if your pan is broken, stained, or starting to leak water, it’s time to replace it. Discover diy concrete pool.
Here’s how to do it without having to remove the tile underneath:
1. Remove the old shower pan by unscrewing the screws at the base. If there are drain holes in the bottom of the pan, pull out the plugs before removing it.
2. Clean the surface of the old pan with a cloth or scrubber and dry off with a towel. If there are any rust spots or corrosion on the metal, try steel wool before cleaning.
3. Sand down any rough edges on the new shower pan using a sandpaper-covered block or an electric sander. Be sure to wear gloves and eye protection if using an electric sander because sparks can fly. If you don’t have a sandpaper block, you can use a bucket with a tight-fitting lid to hold the pan while you sand it. Be careful not to scratch the sides of the pan. You can also use a belt sander to smooth out any rough spots so that the liner will fit together snugly.
4. Cut out holes for the drain holes in the liner using a hole saw or a hacksaw. Find out germinating seeds in paper towel.
5. If you have an epoxy cutter instead of a hole saw, line up the bottom of your new shower pan with your old one and trace around it for the bottom edge of your new shower pan. Then use an electric drill to cut through both pans.
6. Use a sharp knife, utility knife, or scissors to remove any plastic or rubber gasket that may be stuck on the bottom edges of the pans.
7. Remove the old plastic liner from overtop of your new shower pan and line up the new shower pan over it to check for any air gaps. If there are any gaps, carefully trim them out using a razor knife.
8. Once you’ve checked your shower pans for gaps, prepare the adhesive and add it.
Why Should You Replace Your Shower Pan?
If your shower pan is cracked, stained, or starting to fall apart, it’s time to replace it. Replacing a shower pan is a relatively easy DIY project that can save you money and time in the long run. Here are four reasons why you should replace your shower pan:
1. Your shower is leaking water onto the floor.
2. Your shower is flooding your bathroom when it rains.
3. The adhesive that hold the tiles together is beginning to fail.
4. The pan is starting to rust and corrode.
If you’re not sure if your shower pan needs to be replaced, take some measurements first. Ask yourself questions like “How many times has the sealant been replaced?,” “Has there been any visible damage to the tile surface?” or “Do the seams show signs of wear?” If the answer to any of these questions is no, then yourpan probably doesn’t need to be replaced right away. However, if there’s evidence of water damage, deterioration or wear on the tile surface, then it’s time for a new one. Get info about elephant decor.
Conclusion
Shower is one of the most frequently used spaces in your home. But is it really taking advantage of all that this space has to offer? By replacing your shower pan without removing the tile beneath, you can make your bathroom more functional and stylish at the same time. Have a look at the ceiling decorations.
