Overflowing toilet with poop: How to fix it? 6 ways

How to fix overflowing toilet with poop? It is one of the great big questions that many people ask themselves. At the moment, this nauseating problem arises and usually breaks out or occurs. The least opportune moments and what is worse, it can happen in places or houses alien (yes, the perfect storm).

Well, in Practical Resources we prepare an extensive and true guide of salvation for when it is required to know different ways of how to fix the overflowing toilet with poop? Here is the 6 different solution to solve the overflowing.

Table of Contents

How to fix overflowing toilet with poop?

You can review from the forms most common and basic to uncover a bathroom. For home remedies, some curious and ingenious forms become complex and even drastic or brutal to be able to get away with this embarrassing inconvenience.

Pulling the chain several times

Surely, throwing the chain is the most used and logical option to make when you have a covered toilet. Well, this procedure is quite easy to execute (it has no science) and of course. It is necessary to do it as a first step to quickly get out of a problem that may be minor and thus. It is not resorting to other tasks that may require more time and utensils that do not merit use. This method will be used to make sure that the problem is more “fat” than it is appreciated. Another option or way to unclog the toilet is required.

Throw the chain of the pond.
Wait patiently for the water level to drop to the normal level and for the pond to be refilled.
Now, the operation will be repeated again and again until the water drains correctly. In the case that nothing happens then, you should look for another alternative to unclog the toilet. Yes, it’s simple, and it does not have much science.

With a lid

First, you should clear the area and put newspaper or disposable paper around this sanitary device to avoid splashing. You have to mop or clean the bathroom. In addition to this, it is recommended to put on rubber gloves.
After doing the above, take the drain opener and introduce it into the toilet trying to find a seal between the drain opener. The hole where the water drains and to achieve this properly. Tilt it 45 ° approximately the soup to obtain that precious seal.
Once the sealing has been done, the soup will start to sink from top to bottom with energy and repetitively (about 10 to 15 times). It must be executed without lifting the soup so as not to break the seal. Generate the necessary pressure to remove what is clogging the drain and finally, remove the dust.
If the toilet is not uncovered then, you must repeat the operation of putting the toilet lid inside the toilet. Seal the toilet lid from top to bottom and repeat in 10 to 15 times. Do it until it is uncovered.

With a mop

A solution that few know and that serves to uncover a moderately covered bathroom is precisely, to do it with a mop or floor cloth that demands. By the way, a certain skill or ability to be able to do it and be victorious of this problem.

First, they prepare the place by clearing it and covering the adjoining floor with newspaper or disposable paper. Then put on rubber gloves to avoid getting dirty.
Now, take the rag or mop and introduce it to the inside or bottom of the toilet and while they do. They will turn on its axis so that the fringes are rolled up forming a kind of spiral cone and thus achieving a seal.
After doing the above and in the best possible way, the ragpicker was pushed carefully into the interior and then out without removing the created seal, repeating 5 to 10. With this, you can create the suction effect that will allow you to remove. It is generating that partial obstruction of the bathroom. Certainly, they will be able to perceive some result with the sound of drainage. The water drains and they will verify it by pulling the chain of the pond of the bath to see if it is this.
In general, this procedure to unclog the toilet requires some more series with their respective repetitions and of course. It can be executed by people who have a certain skill or ability to handle the mop. Create the seal and generate the indicated suction effect.

With wire or hook

To use this option, you will need to do some manual work at the beginning. Then, have some skill to operate with this homemade utensil created to be able to uncover a toilet of this picturesque shape. It will serve in cases of a mild or medium obstruction.

Prepare the bathroom, clearing anything that can obstruct the work and put on the floor enough daily. Otherwise, use disposable paper to avoid soiling the floor with splashes and having to clean later.
If they are going to use clothes, hook then they will have to disarm. It with the help of some pliers that they have and leave it in the form that imitates one of the siphons.
Now, having the hook of disarmed clothes or the wire that they are going to use. By the way, this must have a suitable caliber to be used inside the toilet.
It will put on rubber gloves, pick up the wire or the clothes hook. Then introduce with some technique and gently, the part of the bit or taco by the siphon and while they do so. They will reach a part of the pipeline that counts more and surely, it is the part where there is something that obstructs then right there. They will do the job of moving the wire or clothes hook inside and out to thus pierce. Push and remove this obstruction and if things go well. You will be noticed when they pull the chain of the pond.

With a hose

A solution that some know and deserves to be disseminated here. It has given the good results it gives in slight or partial obstructions is precisely the possibility of uncovering a bathroom with a hose.

They should clear the bathroom, put diary or disposable paper on the floor to avoid splashing and finally put on rubber gloves.
Now, take the hose and begin to gently insert one of the ends through the pipe or siphon of the toilet to avoid. Some damage and trying with skill and skill that the hose is adapted to the shape of the siphon. It can be in this way, enter as far as possible.
Well, one of the options to unclog the toilet with this option is simply to insert the hose. Take it out, again and again, just to push and remove something that is a bit stuck.
Another option is to use the air pressure and to achieve this, simply introduce the hose to the first part of the siphon. Blow it from the other end of the hose to bring air to the area of the siphon and generate enough pressure to remove.
Another alternative is to create a homemade air propulsion system and to do this, you will need a packing tape and a bottle that can sink or crush easily. Well, join the mouth of the bottle with the hose. By the way, some hoses have a threaded type to join other things like bottles. Seal it as best as possible with the tape.
Well, now they will insert the other end into the toilet until they reach the air area of the siphon. Then, they will crush the bottle quickly and quickly. It will take a breath of air to that area and generate good pressure to remove something that is relatively stuck. By the way, this work can be avoided by using some type of air compressor.

With adhesive tape

A very little known solution to uncover a bathroom is to do it with adhesive tape if, tape or packing that must have a considerable anchor and much better. It is transparent or translucent to see the procedure and check that it gives the expected results.
Like the previous procedures, they will remove everything that can obstruct the procedure. Then, they will cover with newspaper or disposable paper the floor next to the toilet but unlike the others, they will not put on rubber gloves.
So now, they will lift the lid and the toilet seat and after that, they will take some toilet paper and dry neatly or very well the surface of the rim or mouth of the cup. Without leaving any moisture and the used paper will throw it away in some bag.
After doing the above in the best possible way, take the packing tape and stick sections from one edge to the other edge trying to remain tape stretches tight and very close at the ends. For this, you can help with your fingers pressing very well at the extreme points of contact. Well, the idea is that these sections of packaging tape form a real film one after the other. Join with glue on the ends of the cup and on the edges with each other. For that, they should overlap a little one on top of the other.
After doing this kind of “manual” and inspecting that everything is well attached and there is no hole left to cover then, the time for magic arrives and the chain of the pond will be pulled out. With it, the water will begin to fill the cup. If it needs to be filled, they will pull the chain again. The idea is to fill the inside of the toilet bowl with water, generating a great pressure in the drain removing what is clogging the toilet. By the way, filling with water can help more in generating this pressure by putting your hands on the packing tape and pressing inside.

In general, these are the way of how to fix overflowing the toilet with poop is very effective in mild cases or of medium consideration or obstruction.

Decor Ideas