How To Build An Adjustable Concrete Pier

Have you ever wondered how to build a concrete pier? When building a pier or retaining wall, the first step is typically to dig down to the appropriate depth for your project. The next step is to form and reinforce the walls of your pier with slabs that use rebar rods as reinforcement. The next step is to lay out the pier using stakes with string attached; this helps ensure that your pier will be straight. There may also need to be footing blocks added at certain points.

How to Build an Adjustable Concrete Pier?

If you are looking for an easy way to build an adjustable concrete pier, you can use this guide. This process is simple and can be completed in just a few hours.

First, you will need to gather the materials that you will need. You will need a square hole saw, a jigsaw, and some concrete adhesive. Make sure that the hole saw is the right size for the area that you are going to be cutting.

Next, use the jigsaw to cut the hole in the square. Be sure to make sure that the hole is perfectly square. Once the hole is cut, use the concrete adhesive to seal it up. Let the adhesive dry overnight before using your pier.

Steps of Construction

To build an adjustable concrete pier, you will need the following supplies:

– Concrete
– Jigsaw
– Hammer
– Nail Gun
– Level
– Tape Measure
– Chisel
– Pliers
– Tape

1. Begin by marking out the shape of your pier on the ground using a level. Make sure the shape is accurate so that the pier will be symmetrical when it is finished.
2. Next, mix a batch of concrete according to the manufacturer’s instructions. Pour enough concrete into the hole to cover the bottom of your jigsaw blade. Note: The concrete must be at least 3 inches thick for optimal results. If the concrete is too thin, it will not hold the weight of your pier and it may even crack.
3. Cut out the shape of your pier using your jigsaw. Be careful not to cut too deep into the concrete; only cut as far as the jigsaw blade will go. Make sure to remove all of the excess material using your hammer and chisel. Once you have finished cutting, smooth out any rough edges with your sandpaper or a file.
4. Use your level to make sure that the top of the pier is level with the concrete. If it is not, you will need to fill in the gap. Make sure to plug up any holes as you go. 5. When your concrete pier is completely solid and completely dry, you can start assembling your arrows! Place each arrow on top of the others in a vertical orientation at eye-level until you have all of your arrows on the pier.


It can be difficult to get a strong, sturdy foundation for your new garden or deck area. A adjustable concrete pier could be just the solution you are looking for! By using an adjustable concrete pier, you can make sure that the foundation is perfectly level and rigid enough to support whatever load you put it under. Plus, because the pier is adjustable, you can make it as long as you need it to be – perfect for those tricky areas where a solid foundation isn’t possible. Give Adjustable Concrete Pier a try today and see how easy it is to build a sturdy foundation for your next project!

News Reporter

Leave a Reply

Your email address will not be published. Required fields are marked *