Wood is a material that allows us to work with it in many ways, either by painting it, staining it, cutting it, sanding it, or varnishing it. Therefore, today we want to share how to personalize your wood creations with a branding iron.

Wood creations begin to become an addictive task once you have started doing it and see that it is working. With wood, you can make many decorative touches or gifts. Of course, to do this, you need an electric branding iron.

Personalize your wood creations with a branding iron

Wood is the favorite of many to make crafts since this material resists carving, and you can also paint and add other decorative elements. A very beautiful detail that can be done in the wood is to cut in some sentences and decorate special places in your house or room. You can also use names or designs and give them as a special gift. It is a type of art that is unique and shows interest to whom you give it due to the dedication you invest in the work.

If you are very curious about this artwork but have never done it, then it is better to start with a small tool that has a special tip for woodworking. It is also advisable to start with weaker woods until you can master the technique more and work with other types of more resistant woods.

Steps for woodcutting with an electric branding iron

Step 1: Seek the help of a ruler and a pencil and draw a straight line on the wood. There you will write the lyrics that you want to personalize. The advantage of this is that you can start the job again without any problem if you make a mistake. When you do this step, it is important to fix your attention on the width and length of the letters you write. You must leave a small margin to correct errors if you make a mistake when you do the carving process.

Step 2: Clean the wood, and make sure it is free of dust or any porosity.

Step 3: Fix in the electric branding iron a point whose depth is at least 6 mm. If it is a little wide, it will be easier to empty exactly where you have traced the letters that you want to carve.

Step 4: You must start slowly, especially if you do not have experience in the matter. You must also be careful with your hands. A helpful recommendation is to start at the center of the letter and then work towards the edges. When you have let down the letter, then you will proceed again.

Step 5: When all the letters are written, you will have to clean the rest of the dust with a small brush and verify that the letters have been as you wanted.

Step 6: At the end, you can apply a coat of paint or wood varnish.

Tips for using a branding iron

When you have to personalize your wood creations with a branding iron, you will have to consider certain details about the tips of the tools.

First of all, whenever you want to engrave on fine wood, you will have to correctly use the electric branding iron. Similarly, if the letters you want to engrave are small, you will also have to use a fine point.

There are two basic tips to make designs, and everyone who wants to start in this art should know about it.

The casting tips are wider than those for profiling, and their shape is oval or round. With these tips, you draw the lines with a greater thickness in a design or when the part to work is wide. You must choose the tip well for casting because this will depend on the type of wood to be worked.

As for the tips to outline, these are the ones that allow us to draw fine lines, work with edges and contours.

After having finished the design, let us remember that you can continue adding details to the wood. This material allows us to apply paint to embellish your work of wood creations.